Start by laying the bumpers out to the desired spacing.

For mounting on the face of the dock it is not necessary to remove the vinyl edging before mounting the bumpers. It's your option.

Place the bumper in the desired position, place a #10 screw with a finish washer in the center of the upper lip of the bumper, work towards the ends, spacing them approximately 5" apart.

Repeat the process for the bottom side.

Start by laying the bumpers out to the desired spacing.

For this type of mounting format, it is necessary to remove the vinyl edging before mounting the bumpers.

Place the bumper in the desired position with the upper lip over the top of the dock.

Start with a #10 screw and finish washer at the center of the bumper. Work towards the ends placing them approximately 5" apart. Bend the bumper over into position and repeat the process for the bottom side.